• JoomlaWorks Simple Image Rotator
  • JoomlaWorks Simple Image Rotator
  • JoomlaWorks Simple Image Rotator
  • JoomlaWorks Simple Image Rotator
  • JoomlaWorks Simple Image Rotator
  • JoomlaWorks Simple Image Rotator
  • JoomlaWorks Simple Image Rotator
  • JoomlaWorks Simple Image Rotator
  • JoomlaWorks Simple Image Rotator
  • JoomlaWorks Simple Image Rotator
 
  Bookmark and Share
 
 
Master's Dissertation
DOI
https://doi.org/10.11606/D.76.1995.tde-15052009-120635
Document
Author
Full name
Cláudia Bonardi Kniphoff da Cruz
Institute/School/College
Knowledge Area
Date of Defense
Published
São Carlos, 1995
Supervisor
Committee
Oliveira Junior, Osvaldo Novais de (President)
Mattoso, Luiz Henrique Capparelli
Oliveira, Elisabeth Andreoli de
Title in Portuguese
Potencial de superfície de filmes de Langmuir e Langmuir-Blodgett.
Keywords in Portuguese
Filmes de Langmuir
Filmes Langmuir-Blodgett
Potencial de superfície
Abstract in Portuguese
Resultados antigos de potencial de superfície de filmes de Langmuir não eram reprodutíveis, devido B presença de impurezas na subfase aquosa sobre a qual os filmes se formavam. Dados recentes para o ácido esteárico, no entanto, mostram um comportamento reprodutível Neste trabalho, foi promovida com sucesso uma recaracterização através de medidas de pressão de superfície (II) e potencial de superfície (ΔV) de compostos alifáticos simples (álcoois, ésteres, ácido e amina), obtidos sobre subfases devidamente purificadas. Os resultados obtidos são inéditos e mostram que o potencial de superfície desses filmes é nulo para grandes valores de área molecular média (A), aumentando a partir de um valor de área crítico, Acr, até atingir um valor máximo, ΔVmax. Modelos para o potencial de superfície de filmes de Langmuir mostram boa concordância com os resultados obtidos. As curvas de pressão e potencial de superfície para os álcoois e ésteres praticamente não se modificam pela alteração do pH da subfase na faixa de 1 a 13. Porém para a amina e ácido há grandes alterações, principalmente nas curvas de potencial de superfície, em virtude da contribuição da dupla camada elétrica. Foram produzidos, também, filmes de Langmuir-Blodgett (LB) a partir de monocamadas de ácido esteárico que foram caracterizados através de medidas de potencial de superfície, com o objetivo de comprovar a importância da contribuição dipolar para o potencial desses filmes. Os resultados indicam que além da contribuição dipolar, há uma contribuição negativa (em tomo de -200 mV) da interface substrato/filme. O potencial de superfície se confirma como uma técnica de caracterização bastante sensível, tanto para filmes de Langmuir como para filmes LB.
Title in English
Surface potential of Langmuir and Langmuir-Blodgett films.
Keywords in English
Langmuir films
Langmuir-Blodgett films
Surface potential
Abstract in English
Old surface potential data in the literature were not reproducible, because of impurities in the aqueous subphase where the monolayers were formed. Recent data for stearic acid, however, show a reproducible behavior. In this work, a recharacterization of surface presssure (II) and surface potential (ΔV) for Langmuir monolayers of simple aliphatic compounds (alcohols, esters, acid and amine), fabricated over conveniently pure subphases, were successfully carried out. These new results show that the surface potential is zero for large areas per molecule and only increased below a critical area per molecule, Acr. Surface potential models for Langmuir films are in good agreement with the data obtained. There is almost no change in the surface pressure and surface potential for alcohols and esters for a subphase pH range of 1 to 13. However, for amine and acid large changes are observed, mainly in the surface potential curves, because of the electric double layer contribution Langmuir-Blodgett (LB) films were deposited from stearic acid monolayers. They were characterized by surface potential measurements in order to confirm the importance of the contribution from dipole moments of the film-forming molecules. The results also point towards a negative contribution (around - 200 mV) due to the film/substrate interface. The surface potential technique has been demonstrated to be a very sensitive characterization technique for Langmuir monolayers as well as for LB films.
 
WARNING - Viewing this document is conditioned on your acceptance of the following terms of use:
This document is only for private use for research and teaching activities. Reproduction for commercial use is forbidden. This rights cover the whole data about this document as well as its contents. Any uses or copies of this document in whole or in part must include the author's name.
ClaudiaBonardiM.pdf (3.22 Mbytes)
Publishing Date
2009-05-20
 
WARNING: Learn what derived works are clicking here.
All rights of the thesis/dissertation are from the authors
CeTI-SC/STI
Digital Library of Theses and Dissertations of USP. Copyright © 2001-2024. All rights reserved.