• JoomlaWorks Simple Image Rotator
  • JoomlaWorks Simple Image Rotator
  • JoomlaWorks Simple Image Rotator
  • JoomlaWorks Simple Image Rotator
  • JoomlaWorks Simple Image Rotator
  • JoomlaWorks Simple Image Rotator
  • JoomlaWorks Simple Image Rotator
  • JoomlaWorks Simple Image Rotator
  • JoomlaWorks Simple Image Rotator
  • JoomlaWorks Simple Image Rotator
 
  Bookmark and Share
 
 
Master's Dissertation
DOI
https://doi.org/10.11606/D.3.2013.tde-03112014-153454
Document
Author
Full name
Nelson Santos de Oliveira Alves
E-mail
Institute/School/College
Knowledge Area
Date of Defense
Published
São Paulo, 2013
Supervisor
Committee
Futai, Marcos Massao (President)
Almeida, Marcio de Souza Soares de
Palmeira, Ennio Marques
Title in Portuguese
Estudo do comportamento de aterros reforçados sobre solos moles com utilização de drenos verticais pré-fabricados.
Keywords in Portuguese
Aterros reforçados
Aterros sobre solos moles
Drenos verticais
Abstract in Portuguese
Neste trabalho apresentou-se a simulação numérica de aterros reforçado sobre argila mole com uso de drenos verticais pré-fabricados. O objetivo foi analisar o comportamento de um aterro reforçado com geossintético aliado ao uso de drenos verticais pré-fabricados. As análises numéricas de tensão-deformação foram realizadas pelo software PLAXIS 8.2. 2D. Pretendeu-se analisar as influências da rigidez do reforço, espaçamento entre drenos, velocidade de construção, construção do aterro em etapas, no comportamento dos aterros, como recalques verticais, deformações laterais e deformação do reforço. Foi utilizada a metodologia apresentada por Li & Rowe (2001), para a validação da modelagem dos aterros. A calibração do programa foi feita com a literatura de aterros reforçados. Nos resultados apresentados foram verificadas vantagens, como por exemplo: aceleração dos recalques e possibilidade da construção de aterros mais altos. O MEF mostrou que pode ser útil na escolha do reforço mais adequado para a condição de obra desejada, juntamente com espaçamento entre drenos. Foi possível verificar que a combinação de ambos os elementos pode ser bastante vantajosa em relação à utilização de apenas um deles. As deformações do reforço determinadas pelo MEF podem ser usadas para escolher o reforço adequado para um aterro sobre solo mole. Através dos resultados do método de elementos finitos pretendeu-se definir uma metodologia para calcular as deformações do reforço para uma altura de aterro determinada.
Title in English
Study of the behavior of reinforced embankments on soft soils with use of pre-fabricated vertical drains.
Keywords in English
Embankments on soft soils
Reinforced embankments
Vertical drains
Abstract in English
This paper presents the numerical simulation of reinforced embankment on soft clay with the use of prefabricated vertical drains. The objective is to analyze the behavior of a geosynthetic reinforced embankment along with the use of prefabricated vertical drains. The numerical analyzes of the stress-strain were performed by software PLAXIS 8.2. 2D. It was intended to analyze the influence of the stiffness of the reinforcement spacing between drains, construction speed, construction of the embankment in stages, the behavior of the landfill as settlements vertical, lateral deformations and deformation strengthening. We used the method presented by Li & Rowe (2001), to validate the modeling of landfills. The calibration was performed with the program literature reinforced embankments. In the following results were observed advantages such as: speeding up the possibility of repression and construction of embankments higher. MEF showed that may be helpful in selecting the most suitable for enhancing the desired work condition, with the spacing between drains. It can be seen that the combination of both elements can be quite advantageous over the use of just one. The deformation of the reinforcement determined by MEF can be used to choose the proper reinforcement for an embankment on soft soil. Through the results of the finite element method was intended to define a methodology to calculate the deformations of the reinforcement to a height of embankment determined.
 
WARNING - Viewing this document is conditioned on your acceptance of the following terms of use:
This document is only for private use for research and teaching activities. Reproduction for commercial use is forbidden. This rights cover the whole data about this document as well as its contents. Any uses or copies of this document in whole or in part must include the author's name.
Publishing Date
2014-11-04
 
WARNING: Learn what derived works are clicking here.
All rights of the thesis/dissertation are from the authors
CeTI-SC/STI
Digital Library of Theses and Dissertations of USP. Copyright © 2001-2024. All rights reserved.