• JoomlaWorks Simple Image Rotator
  • JoomlaWorks Simple Image Rotator
  • JoomlaWorks Simple Image Rotator
  • JoomlaWorks Simple Image Rotator
  • JoomlaWorks Simple Image Rotator
  • JoomlaWorks Simple Image Rotator
  • JoomlaWorks Simple Image Rotator
  • JoomlaWorks Simple Image Rotator
  • JoomlaWorks Simple Image Rotator
  • JoomlaWorks Simple Image Rotator
 
  Bookmark and Share
 
 
Doctoral Thesis
DOI
https://doi.org/10.11606/T.3.2007.tde-08012008-144158
Document
Author
Full name
Kátia Franklin Albertin
E-mail
Institute/School/College
Knowledge Area
Date of Defense
Published
São Paulo, 2007
Supervisor
Committee
Pereyra, Ines (President)
Diniz, José Alexandre
Santos Filho, Sebastião Gomes dos
Sonnenberg, Victor
Swart, Jacobus Willibrordus
Title in Portuguese
Estudo de camadas dielétricas para aplicação em capacitores MOS.
Keywords in Portuguese
Capacitores
Dielétricos (propriedades)
Dispositivos semicondutores
Estrutura dos materiais
Silício
Abstract in Portuguese
Foram estudados filmes de oxinitreto de silício obtidos por PECVD à 320°C, a partir da mistura gasosa de N2O+SiH4+He, com diferentes valores de pressão e potência de deposição com o objetivo de produzir boa qualidade de interface deste material com o Si e de obter uma baixa densidade de carga efetiva visando a aplicação desses filmes em dispositivos semicondutores MOS. Os resultados mostraram que com uma pressão de deposição de 0,160 mbar e potências menores que 125 W/cm2 é possível obter um valor de densidade de estados de interface (Dit) de 4x1010 eV-1.cm-2, campo elétrico de ruptura (Ebd) de 13 MV/cm, valores comparáveis ao SiO2 térmico e uma densidade de carga efetiva (Nss) de 4x1011 cm-2. Segundo resultados experimentais esse valor de Nss é o mínimo possível que se pode atingir com a limpeza química utilizada em nosso laboratório. Pode-se dizer que estes são resultados bastante interessantes considerando que se trata de um material obtido por PECVD à baixa temperatura, porém viável para aplicação em dispositivos MOS. Iniciando os estudos com dielétricos de maiores valores de constante dielétrica optamos por estudar filmes de TiOx (k=40-100), obtidos por sputtering reativo, a partir da mistura gasosa de Ar+O2 e utilizando alvo de Ti. Foram fabricados capacitores MOS com estes filmes e obteve-se valores de constante dielétrica que variaram de 40-160. Porém esses materiais ainda apresentavam valores apreciáveis de corrente de fuga que foram minimizadas em ordens de grandeza quando utilizados dielétricos de dupla camada com SiO2 ou SiOxNy (otimizado neste trabalho) na interface, além de se observar uma melhora significativa da qualidade de interface. Utilizando dupla camada dielétrica com filmes de SiOxNy e SiO2, ainda espessos (³ 1nm) para camada intermediária, obteve-se uma constante dielétrica efetiva em torno de 20. Vale ressaltar que os dois filmes SiOxNy e TiOx, conseqüentemente a dupla camada, foram fabricados a baixas temperaturas.
Title in English
Study of dielectric layers for MOS capacitors.
Keywords in English
High k dielectrics
Low temperature
MOS capacitors
Silicon oxynitride
Titanium oxide
Abstract in English
Silicon oxynitride films obtained by the PECVD technique from N2O+SiH4+He gaseous mixtures, at 320°C, with different deposition pressure and RF power were studied intending to improve the interface quality with Si, decreasing the effective charge density and the interface state density in order to utilize them in MOS semiconductor devices. The results showed that with a deposition pressure of 0.160 mbar and a RF power density lower than 125 W/cm2 it is possible to obtain interface state density (Dit) values of 4x1010 eV-1.cm-2, Electrical Breakdown (Ebd) of 13 MV/cm, comparable with the obtained for thermally grown SiO2 , and an effective charge density (Nss) of 4x1011 cm-2. According with experimental results this Nss value is the minimum attainable with our chemical cleaning process. In this way it can be said that these results are very promising, considering that these materials were obtained by PECVD at low temperatures, but still viable for MOS devices application. In order to initiate studies with high dielectrics constant material, TiOx films (k= 40-180), obtained by reactive sputtering through the Ar+O2 gaseous mixture utilizing a Ti target, were chosen. MOS capacitors with these films were fabricated and dielectric constant values varying from 40 to 160 were obtained. However, until now, these materials have presented appreciable leakage current values, which were, minimize by orders of magnitude with the addition of a thin SiO2 or SiOxNy (optimized in this work) layer at the interface were utilized. This thin layer also resulted in a significant improvement of the interface quality. Utilizing double dielectric layer with SiOxNy or SiO2, still thick (³ 1nm) as intermediate layer a dielectric constant value of 20 was obtained. Its important to mention that the SiOxNy and TiOx films, and consequently the double layer, were deposited at low temperatures.
 
WARNING - Viewing this document is conditioned on your acceptance of the following terms of use:
This document is only for private use for research and teaching activities. Reproduction for commercial use is forbidden. This rights cover the whole data about this document as well as its contents. Any uses or copies of this document in whole or in part must include the author's name.
Publishing Date
2008-02-07
 
WARNING: Learn what derived works are clicking here.
All rights of the thesis/dissertation are from the authors
CeTI-SC/STI
Digital Library of Theses and Dissertations of USP. Copyright © 2001-2024. All rights reserved.