• JoomlaWorks Simple Image Rotator
  • JoomlaWorks Simple Image Rotator
  • JoomlaWorks Simple Image Rotator
  • JoomlaWorks Simple Image Rotator
  • JoomlaWorks Simple Image Rotator
  • JoomlaWorks Simple Image Rotator
  • JoomlaWorks Simple Image Rotator
  • JoomlaWorks Simple Image Rotator
  • JoomlaWorks Simple Image Rotator
  • JoomlaWorks Simple Image Rotator
 
  Bookmark and Share
 
 
Master's Dissertation
DOI
https://doi.org/10.11606/D.18.2011.tde-27042011-085423
Document
Author
Full name
Amilcar Flamarion Querubini Gonçalves
Institute/School/College
Knowledge Area
Date of Defense
Published
São Carlos, 2011
Supervisor
Committee
Machado, Ricardo Quadros (President)
Pomilio, Jose Antenor
Ramos, Rodrigo Andrade
Title in Portuguese
Controle e análise de conversores CC-CA conectados em redes de distribuição e utilizados em sistemas de geração distribuída
Keywords in Portuguese
Conversores trifásicos
Eletrônica de potência
Geração distribuída
Abstract in Portuguese
O presente trabalho visa o desenvolvimento de metodologias para a conexão de sistemas de Geração Distribuída (GD) em redes de distribuição utilizando conversores CC-CA como também, a produção de energia elétrica dentro dos padrões estabelecidos por normas nacionais e internacionais. Para a produção de energia com índices de qualidade satisfatórios, duas situações vão ser consideradas: uma quando o sistema está conectado à rede e outra quando a rede está indisponível. Após a ocorrência do ilhamento, é necessária a mudança da variável a ser sintetizada pelo conversor CC-CA, ou seja, antes da contingência ocorrer a GD está sendo gerenciada no modo potência e/ou corrente e após passa a ser controlada no modo tensão. Além disso, espera-se que os resultados obtidos forneçam subsídios às concessionárias de energia elétrica e aos produtores e autoprodutores de energia para a conexão sistemas de geração distribuída em redes de distribuição como também, os procedimentos necessários a serem adotados por eles quando o sistema de distribuição estiver sob contingência (ilhamento).
Title in English
Analysis and control of DC-AC power converters connected to a distribution grid and use in distributed generation system
Keywords in English
Control of converters
Distributed generation
Dynamic systems
Power electronics
Three-phase converters
Abstract in English
This work proposes a set of analysis to connecting a distributed generation system to a distribution network using a three-phase power converter (DC-AC) as well as, the power generation produced by the DG (Distributed Generation) system must follow the national and international power quality standards. For producing energy with satisfactory power quality indexes, two situations will be considered: when the power converter operates connected to the grid, the power/current is used as control variable. However, if the power converter is operating in stand-alone mode (contingency or islanding mode) the control variable must be changed to voltage and the terminal voltage of the power converter must be controlled. Finally, the main concerning of the present study is to obtain results to the electrical energy companies and self-producers for connecting DG system to the grid as well as, the essential procedures that must be adopted by them when the distribution system is operating in contingency or islanding mode.
 
WARNING - Viewing this document is conditioned on your acceptance of the following terms of use:
This document is only for private use for research and teaching activities. Reproduction for commercial use is forbidden. This rights cover the whole data about this document as well as its contents. Any uses or copies of this document in whole or in part must include the author's name.
Amilcar.pdf (1.84 Mbytes)
Publishing Date
2011-04-27
 
WARNING: Learn what derived works are clicking here.
All rights of the thesis/dissertation are from the authors
CeTI-SC/STI
Digital Library of Theses and Dissertations of USP. Copyright © 2001-2024. All rights reserved.