• JoomlaWorks Simple Image Rotator
  • JoomlaWorks Simple Image Rotator
  • JoomlaWorks Simple Image Rotator
  • JoomlaWorks Simple Image Rotator
  • JoomlaWorks Simple Image Rotator
  • JoomlaWorks Simple Image Rotator
  • JoomlaWorks Simple Image Rotator
  • JoomlaWorks Simple Image Rotator
  • JoomlaWorks Simple Image Rotator
  • JoomlaWorks Simple Image Rotator
 
  Bookmark and Share
 
 
Master's Dissertation
DOI
https://doi.org/10.11606/D.18.1999.tde-05012004-151230
Document
Author
Full name
Márcio Albuquerque Silveira
E-mail
Institute/School/College
Knowledge Area
Date of Defense
Published
São Carlos, 1999
Supervisor
Committee
Soria, Manoel Henrique Alba (President)
Coelho, Vladimir
Fabbri, Glauco Tulio Pessa
Title in Portuguese
Estudo sobre adição de polímero em areia-asfalto a frio
Keywords in Portuguese
areia-asfalto
emulsão
misturas a frio
pavimentação
polímero
Abstract in Portuguese
O revestimento de areia-asfalto a frio, ainda que pouco utilizado, é uma alternativa importante para construção de rodovias de baixo volume de tráfego no Estado do Ceará. Neste trabalho é apresentado estudo comparativo entre misturas de areia-asfalto fabricadas a frio com a utilização de emulsão asfáltica convencional e emulsão modificada com polímero. O objetivo da pesquisa é avaliar, através de ensaios de creep dinâmico, creep estático e o ensaio de desgaste Cantabro, se o uso da emulsão modificada com polímero resulta em uma mistura de areia-asfalto a frio mais resistente ao desgaste e à deformação permanente. As misturas asfálticas analisadas nesta pesquisa apresentaram boa resistência ao desgaste, mas em virtude das dificuldades ocorridas nos ensaios de creep não foram encontradas evidências de que o uso de emulsão modificada com polímero produzisse uma mistura de areia-asfalto a frio mais resistente
Keywords in English
cold mixes
emulsion
polymer
sand-asphalt
Abstract in English
Cold sand-asphalt surface layer, although not widely used, is an important alternative for construction of low traffic roads in Ceará State. This work presents a comparative study between cold sand-asphalt mixtures produced with standart asphaltic emulsion and polymer modified emulsion. The aim of this research is to evaluate, with use of dynamic and static creep tests and the Cantabro wear out test, if the use of a polymer modified emulsion would result in a cold sand-asphalt mixture more resistent to wear out and permanent deformation. The asphaltic mixes analyzed in this research presented high wear out resistence, but due to dificulties occurred in creep tests there were not found evidences that the use of polymer modified emulsion would produce a more resistent cold sand-asphalt mixture
 
WARNING - Viewing this document is conditioned on your acceptance of the following terms of use:
This document is only for private use for research and teaching activities. Reproduction for commercial use is forbidden. This rights cover the whole data about this document as well as its contents. Any uses or copies of this document in whole or in part must include the author's name.
0_pre_texto.pdf (25.52 Kbytes)
1_Introducao.pdf (10.31 Kbytes)
2_Dados.pdf (226.26 Kbytes)
6_Resultados.pdf (121.66 Kbytes)
8_Referencias.pdf (22.53 Kbytes)
9_pos_texto.pdf (24.70 Kbytes)
Publishing Date
2004-03-25
 
WARNING: Learn what derived works are clicking here.
All rights of the thesis/dissertation are from the authors
CeTI-SC/STI
Digital Library of Theses and Dissertations of USP. Copyright © 2001-2024. All rights reserved.