• JoomlaWorks Simple Image Rotator
  • JoomlaWorks Simple Image Rotator
  • JoomlaWorks Simple Image Rotator
  • JoomlaWorks Simple Image Rotator
  • JoomlaWorks Simple Image Rotator
  • JoomlaWorks Simple Image Rotator
  • JoomlaWorks Simple Image Rotator
  • JoomlaWorks Simple Image Rotator
  • JoomlaWorks Simple Image Rotator
  • JoomlaWorks Simple Image Rotator
 
  Bookmark and Share
 
 
Master's Dissertation
DOI
https://doi.org/10.11606/D.18.2004.tde-12072006-103303
Document
Author
Full name
Fabiana Stripari Munhoz
E-mail
Institute/School/College
Knowledge Area
Date of Defense
Published
São Carlos, 2004
Supervisor
Committee
Giongo, Jose Samuel (President)
Machado, Claudinei Pinheiro
Venturini, Wilson Sergio
Title in Portuguese
Análise do comportamento de blocos de concreto armado sobre estacas submetidos à ação de força centrada
Keywords in Portuguese
bielas e tirantes
blocos sobre estacas
concreto armado
fundações
Abstract in Portuguese
Este trabalho estuda o comportamento de blocos rígidos de concreto armado sobre uma, duas, três, quatro e cinco estacas, submetidos à ação de força centrada. Com o objetivo de contribuir para critérios de projeto, utilizaram-se resultados obtidos por meio de modelos analíticos e realizou-se análise numérica utilizando-se programa baseado no método dos elementos finitos. Foi desenvolvida, ainda, uma análise comparativa entre os processos de dimensionamento adotados em projeto, na qual se verificou grande variabilidade dos resultados. Para análise numérica adotou-se comportamento do material como elástico linear e os resultados de interesse foram os fluxos de tensões em suas direções principais. Nos modelos adotados variaram-se os diâmetros de estacas e dimensões de pilar, a fim de se verificar as diferenças na formação dos campos e trajetórias de tensões. Concluiu-se que o modelo de treliça utilizado em projetos é simplificado e foram feitas algumas sugestões para a utilização de um modelo de bielas e tirantes mais refinado. Foi possível a verificação da influência da variação da geometria de estacas e de pilares no projeto de blocos sobre e a revisão dos critérios para os arranjos das armaduras principais. Para os modelos de blocos sobre cinco estacas adotados concluiu-se que o comportamento não é exatamente como considerado na prática
Title in English
Analysis of reinforced concrete pile-caps behaviour subjected to center top surfaces loading
Keywords in English
footings
pile-caps
reinforced concrete
strut-and-tie
Abstract in English
This work describes the behavior of rigid reinforced concrete pile-caps with one, two, three, four and five piles subjected to patches of loading on the center top surfaces of the column. Programs based on finite elements method were used to obtain numerical results and results obtained by means of analytic models were used. A comparative analysis was developed among the processes adopted in design, which large variability of the results was verified. An elastic linear behavior of the material was adopted for numerical analysis and interest results were stress paths along main directions. Piles diameters and column dimensions of the models were been varied, in order to verify the differences in the formation of the regions and trajectories of stress. It is ended that used the truss model is simplified. Some suggestions were made for the use of a more refined strut-and-tie model than the one used in design and it was possible the verification of the variation geometry of piles and columns influence. It was still made a revision of the reinforcement layouts. The conclusion for adopted five-pile-caps was that the behavior is not exactly as considered in the practice
 
WARNING - Viewing this document is conditioned on your acceptance of the following terms of use:
This document is only for private use for research and teaching activities. Reproduction for commercial use is forbidden. This rights cover the whole data about this document as well as its contents. Any uses or copies of this document in whole or in part must include the author's name.
Publishing Date
2006-07-13
 
WARNING: Learn what derived works are clicking here.
All rights of the thesis/dissertation are from the authors
CeTI-SC/STI
Digital Library of Theses and Dissertations of USP. Copyright © 2001-2024. All rights reserved.